The More Versatile CLASSIC HANDPIECE
versatile Classic is
the same handpiece as its predecessor, but the new bore is easily
replaceable with a removable sleeve. The Classic comes standard
with a stainless piston. A second piston (tungsten dead blow) can be purchased for additional power.
Three handpiece tubing attachment locations for customability and comfort.
Non-slip rubber handle. Full stroke adjustment. Rapid 3/32" square graver change without collets.
Lindsay gravers are made form surgical stainless steel. No aluminum is used in
the construction of the tool.
The tool's patent pending removable bore provides for an extra air pocket in the handpiece. This pocket is ported
to the rear chamber, providing the following improvements:
changes directions in the rear chamber gradually, resulting in less
vibration, smoother cutting and less noise.
The piston hesitates for a few microseconds in the front chamber following an impact stroke, giving
the effect of what is known as a "dead blow". This is what occurs when a hammer hits an anvil and there is no recoil. The impact inertia is transferred
through the anvil to the graver with no bounce. The result is less vibration, and more energy transferred to
patented idle is
improved. The idling handpiece can be turned down finer than prior handpieces, and, with the stainless piston, can be turned down so low that
it is not felt. The tool will idle with less air (or CO2), as well as more
easily maintain an idling state. Small amounts of oil from an older
unfiltered air compressor do not affect the idle as much as on prior
---Click here to see a Gallery of work created
with the Classic AirGraver---
|Optional custom burl wood handle for foot pedal Classic handpiece
The Classic handpiece comes with a stainless piston. A tungsten dead blow
piston can be purchased separately. Tungsten weights 2.5 to 3 times than stainless and provides heavier impact power for deeper engraving, carving or
Left: Classic handpiece with a PalmControl handle set up to run from a pocket sized
CO2 cartridge. Click to enlarge
Classic Handpiece Impact speed range
Stainless piston = 2,400 through 15,000 strokes per minute.
Tungsten Dead Blow™
piston = 1,500 through 11,000 strokes per minute.
|The length of stroke
adjustment collar on the Classic handpiece provides a multitude of hand pieces
in one tool. At any given stroke length setting, the power is varied with air pressure
from the foot control or PalmControl (.5psi to 60psi). The absence of
an internal spring means uniform performance throughout the range,
with no sweet spots or non-working spots. The full range of power and
speed is consistent throughout due to the internal automatic balance
of air pressure on both the impact and return strokes.
||The tool requires little air volume for operation. 0.05 to 0.2 CFM depending on the depth of engraving or impact operation. This means the life of an air compressor will last longer and a smaller compressor can be used.
The Classic handpiece includes length/speed
stroke collar, rapid graver
change, a Teflon bore in a 303 stainless body, and
a hardened 440C stainless piston, anvil, and nose. No collects
required for rapid graver change. Also included are
three high speed
steel 3/32" square
graver blanks, a leather handpiece pouch, extra screws, wrench and
owner's manual. Requires 60psi regulated compressed air from an air
Classic handpiece with Foot control, idle adjust and dual regulators
Includes stainless piston and $125 tungsten piston
Classic handpiece with PalmControl
Tungsten Dead Blow Piston