Ball Vise Features:
pin plates and lead screw are hardened stainless
*Adjustable friction brake
*Pin plates have pin holes with a
smaller hole through the plate for ease of cleaning out the
*Threaded holes in jaws accept pin plates or custom fixtures.
Multi-Coin jaws screw
right on the PalmControl vise jaws.
*Jaw width 1.75"
jaw opening 2.4"
*Includes pin plates, pins, base and wrench.
weight 14 lbs.
If you try and add one to your cart but the cart says zero (0) it
means they are out of stock. More very close!
PalmControl® Vise shipping within USA $454
Steve Lindsay's tip: The metal base is leather
lined. From one engraver to another some like and engrave
ball to stay in place with good grip when it is tilted and others
like to tilt the vise around about as much as rotating it and so
they like less grip. The vises are shipped with the amount
of grip Steve prefers smooth move but with some grip to stay in
place. If you prefer a ball vise with less grip then
you can rub a little cornstarch on the leather. In this way
the amount of grip can be adjusted. If you get it with
less grip than you were wanting you can give it more grip again by
sticking tape on the leather and pulling it up in order to clean
some of the cornstarch off.
Wrenches for PalmControl Vises, and Small
Self-holding t-wrench, pat. pend. is small enough that it can be
left in place while engraving, so no more looking for the wrench.
Or it can be removed. Hex is made from tool steel that is
hardened and tempered. The T is stainless.
Round Brass Knurl Wrench for PalmControl vise, and small CamLock
vise. -- $24.00
Self-Holding T Wrench for PalmControl Vise, and small CamLock
vise. -- $46.00
Leather Ring Fixture for Vise pin plates
Place these in vise pin plates to hold rings or other items.
the pin plates on the
Low Profile vise, later Goliath
vises and PalmControl® vises.
Find more information about these holders on the
vise accessory page.
Leather Ring Holder: $56
Gravity™ Ring Holder
Gravity Ring Holder for PC Vise
(centers only) $49
Gravity Ring Holder for Goliath (centers only) $57
Brass 6 finger collet $25
Brass 12 finger collet $35
these in vise pin plates to hold rings from the outside, to
allow inside engraving, as well as access to the top of the
ring. They are made from solid stainless and the faces are
leather lined. Find more information about these holders
on the vise accessory page.
Inside Ring Holder for Vise pin plates
The jaws of the multi coin holder
will bolt directly to the jaws of the PalmControl Vise once the
pin plates are remove.
Vises home page link